Re: IDE problems from yesterday
- Posted by Ray Tomes <rtomes at ihug.co.nz> Jun 22, 2003
- 373 views
Hi Judith [with regard to problem in IDE] Judith Evans wrote: > You were editing a control in Properties? No, I was moving or resizing (I think it happens with either of these) a control on the big Form Design part. The control was on a tab with (as you might guess) multiple tabs. If I click on the same tab when I am finished with moving and resizing the control, then all is fine. However if I click on the top of a different tab (when the control is still active (showing the 4 little corner triangles), then rather than change tabs it locks up. Clicking anywhere on the Form Design then has no effect. However clicking a tab in the tree structure (in lower left) unlocks things and it works again. Once I understood what was happening it was only a minor annoyance, but until then it caused me a few repeats on doing changes. Please remember I am very new to this, so I hope I am not doing something dumb. All the best Ray Tomes