OpenEuphoria

Re: can't figure this out

• Posted by George Walters <gwalters at sc.rr.com> Aug 29, 2001
• 433 views

Thanks for all the comments. I don't know why I couldn't see the problem.
It's important to use the correct mask's! Nice to have all this help out
there. When you're writing a pgm you tend to see what you are trying to do
not what you are actually doing..

...george

----- Original Message -----
From: "George Walters" <gwalters at sc.rr.com>
To: "EUforum" <EUforum at topica.com>
Subject: Re: can't figure this out


>
> Bernie... run this
>
> sequence screenTable, tmp
>
> screenTable = {0,0,0,0,0,0,2,8}
>
>
> printf(1,"%d  %d\n",{screenTable[8],screenTable[7]})
> tmp = sprintf("%d",screenTable[8])&"."&sprintf("%d",screenTable[7])
> printf(1,"%4.2f\n",tmp)
>
> tmp = gets(0)
>
>
> ...george
> ----- Original Message -----
> From: "Bernie Ryan" <xotron at localnet.com>
> To: "EUforum" <EUforum at topica.com>
> Sent: Tuesday, August 28, 2001 6:33 PM
> Subject: RE: can't figure this out
>
>
> > George Walters wrote:
> > > Here's the code...
> > >
> > >  printf(1,"%d  %d\n",{screenTable[i][8],screenTable[i][7]})        --
> > >  this
> > > prints a 9 and a 2  so table8 is 9 and table7 is 2
> > >
> > >    tmp =
> > > ntf("%d",screenTable[i][8])&"."&sprintf("%d",screenTable[i][7])     --
> > > if i
> > > print this with a printf i get 57.00 ???????
> > >
> > > why is tmp not 9.2 ??
> > >
> > >
> > george:
> >
> >   Are you sure that the value [i] is the same? Try printing it
> >   out at the same point in your program loop
> > Bernie
> >
> >
>
>