OpenEuphoria

Re: Euphoria Sound System?

• Posted by Nick Metcalfe <metcalfn at ALPHALINK.COM.AU> Oct 14, 1999
• 778 views

--------------7C2129C2676436FCD7AE42FE



Bernie Ryan wrote:

> I have a ISA AWE32 and can do a loop back of the midi interface. Where is
> the file located on your web site. What is the file called. If its not too
> large can't you attach it to your e-mail ?
> Bernie

Hi Bernie.  Thanks for volunteering your services   I haven't put the file
on my web page 'cause its way too incomplete and I change it every day.
Anyway, here 'tis..

When the program is run, it should show setup debugging information and
then play a low tone through the sb.  At the same time, it will be
sending and monitoring loopback data through the midi port.  Any data
errors will increment the "Errors:" counter.  This will continue until
the esc key is pressed.

If the Errors counter shoots up and it says nothing but "Bad!" then the
loopback may not be connected properly.  If it sends most blocks ok, but
occasionaly says "Bad!" and increases Errors,  then I can assume it's
the code 'cause this is precisely what happens to me.  If no errors
happen for at least a minute or so then I can assume it's my card and
get a new one.

Thanks again.  Hope to hear from you soon,

--
  Nick Metcalfe <metcalfn at alphalink.com.au>
  http://www.alphalink.com.au/~metcalfn


--------------7C2129C2676436FCD7AE42FE