1. Re: IDE problems from yesterday
Ok, that explanation answers my question, thank you.
--judith
Ray wrote:
[with regard to problem in IDE]
Judith Evans wrote:
You were editing a control in Properties?
No, I was moving or resizing (I think it happens with either of these) a
control on the big Form Design part. The control was on a tab with (as you
might guess) multiple tabs. If I click on the same tab when I am finished
with moving and resizing the control, then all is fine.
However if I click on the top of a different tab (when the control is
still active (showing the 4 little corner triangles), then rather than
change tabs it locks up. Clicking anywhere on the Form Design then has no
effect. However clicking a tab in the tree structure (in lower left)
unlocks things and it works again.
Once I understood what was happening it was only a minor annoyance, but
until then it caused me a few repeats on doing changes.
Please remember I am very new to this, so I hope I am not doing something
dumb.
All the best
Ray Tomes
